A Craftsman garage door opener keypad is a convenient way to access your garage without using a remote control. If you’ve recently installed a new keypad or reprogramming craftsman garage door opener an old one, programming it correctly is essential. In this guide, we’ll take you through the step-by-step process of programming a Craftsman garage door opener keypad.
Step 1: Locate the "Learn" Button
The first step in programming your keypad is to find the "Learn" button on the garage door opener unit. This button is usually located on the back or side of the motor housing and may be red, yellow, purple, or green.
Step 2: Enter Programming Mode
Press and release the "Learn" button. The indicator light next to it will turn on, meaning the system is in programming mode.
You now have 30 seconds to complete the next steps.
Step 3: Set Up the Keypad Code
On your Craftsman keypad, enter a four-digit PIN of your choice.
Press and hold the Enter button until the garage door opener light blinks or clicks.
Once the light blinks, release the Enter button. Your new code is now set!
Step 4: Test the Keypad
Close the garage door completely.
Enter your newly programmed four-digit PIN on the keypad.
Press Enter—the garage door should open. If it doesn’t, repeat the programming steps carefully.
Step 5: Reset the Keypad (If Necessary)
If you need to reset the keypad due to a forgotten PIN or malfunction, follow these steps:
Press and hold the Learn button for 6-10 seconds until the indicator light turns off.
This erases all previously stored keypad and remote settings.
Reprogram the keypad using the steps outlined above.
Additional Tips for Successful Programming
Choose a secure PIN that’s easy for you to remember but hard for others to guess.
Replace the keypad battery if it doesn’t respond properly (most use a 9V battery).
Keep the keypad clean and dry to prevent button malfunctions.
If you have multiple garage doors, ensure you're programming the keypad to the correct opener.
Final Thoughts
Programming a Craftsman garage door opener keypad is quick and straightforward when following the correct steps. If you encounter any issues, double-check your PIN entry, battery level, or garage door opener settings.